REAR SEAT OUTER BELT ASSEMBLY (for Sedan) > REMOVAL |
| 1. REMOVE REAR SEAT ASSEMBLY (for 60/40 Split Seat Type LH Side) |
| 2. REMOVE REAR SEAT ASSEMBLY (for 60/40 Split Seat Type RH Side) |
| 3. REMOVE SPARE WHEEL COVER ASSEMBLY |
![]() |
Remove the spare wheel cover assembly.
| 4. REMOVE LUGGAGE COMPARTMENT TRIM INNER PAD |
![]() |
Remove the luggage compartment trim inner pad.
| 5. REMOVE REAR DOOR SCUFF PLATE RH |
![]() |
Disengage the 7 claws and remove the rear door scuff plate.
| 6. REMOVE REAR DOOR SCUFF PLATE LH |
| 7. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH |
![]() |
Remove the rear door opening trim weatherstrip.
| 8. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH |
| 9. REMOVE REAR SEAT SIDE COVER RH |
![]() |
Disengage the 2 clips and the 4 claws and remove the rear seat side cover.
| 10. REMOVE REAR SEAT SIDE COVER LH |
| 11. REMOVE ROOF SIDE INNER GARNISH RH |
![]() |
Disengage the 4 clips and the claw and remove the roof side inner garnish.
| 12. REMOVE ROOF SIDE INNER GARNISH LH |
| 13. REMOVE HIGH MOUNTED STOP LIGHT ASSEMBLY |
![]() |
Disengage the 2 claws.
![]() |
Disengage the 2 claws.
Disconnect the connector and remove the high mounted stop light assembly.
| 14. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY |
![]() |
Using a clip remover, remove the 4 clips.
Disengage the 5 claws and remove the package tray trim panel.
| 15. REMOVE REAR SEAT OUTER BELT ASSEMBLY |
![]() |
Remove the bolt.
Disengage the 2 claws and remove the anchor plate.
![]() |
Remove the bolt, the hook and the retractor.
| 16. REMOVE SEAT BELT HOLE SEAL |
![]() |
Disengage the 2 claws and remove the seat belt hole seal.