DOOR CONTROL SWITCH (for Sedan) > REMOVAL |
| 1. REMOVE FRONT ARMREST BASE UPPER PANEL |
![]() |
for Driver Side:
Remove the screw.
Disengage the 2 clips and the 7 claws.
Disconnect the connector and remove the front armrest base upper panel.
![]() |
for Front Passenger Side:
Remove the screw.
Disengage the 2 clips and the 7 claws.
Disconnect the 2 connectors and remove the front armrest base upper panel.
| 2. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (for Driver Side) |
![]() |
Remove the 3 screws and the power window regulator master switch assembly.
| 3. REMOVE DOOR CONTROL SWITCH (for Front Passenger Side) |
![]() |
Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the door control switch.
| *a | Protective Tape |