Home › Vehicle Interior › DOOR LOCK › DOOR CONTROL SWITCH (for Sedan)

DOOR CONTROL SWITCH (for Sedan) > REMOVAL



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE FRONT ARMREST BASE UPPER PANEL


B136158
  1. for Driver side with power window:

    1. Remove the screw.

    2. Disengage the 7 claws and 2 clips and remove the front armrest base upper panel.

    3. Disconnect the connector.



    B141925
  1. for Front passenger side with power window:

    1. Remove the screw.

    2. Disengage the 7 claws and 2 clips and remove the front armrest base upper panel.

    3. Disconnect the connector.



    B141926
  1. w/o Power window:

    1. Remove the screw.

    2. Disengage the 5 claws and 2 clips and remove the front armrest base upper panel.



3. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (w/ Power Window)


B136183
  1. Remove the 3 screws and the power window regulator master switch assembly.



4. REMOVE DOOR CONTROL SWITCH


B141927
  1. for Front passenger side with power window:
    Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the door control switch.



    B141928
  1. w/o Power window:
    Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the door control switch.