REAR DOOR LOCK (for Sedan) > INSTALLATION |
| 1. INSTALL REAR DOOR LOCK |
Apply MP grease to the sliding and rotating areas of the front door lock.
![]() |
Connect the rear door lock remote control cable and rear door inside locking cable.
![]() |
Close the 2 covers.
Insert the door lock into the outside handle frame release plate, then set it onto the door panel.
Make sure that the outside handle frame link is securely engaged with the door lock.
Apply adhesive to the threads of the screws.
![]() |
Using "TORX" socket wrench T30, install the rear door lock with the 3 screws.
| 2. INSTALL REAR DOOR GLASS SUB-ASSEMBLY |
![]() |
w/ Power window:
Install the rear door glass onto the rear door window regulator.
![]() |
w/o Power window:
Install the rear door glass onto the rear door window regulator.
| 3. INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY |
![]() |
Install the rear door window division bar with the 2 bolts and screw.
| 4. INSTALL REAR DOOR GLASS RUN |
![]() |
Install the rear door glass run.
| 5. INSTALL REAR DOOR BELT MOULDING |
![]() |
Engage the 5 claws and install a new rear door belt moulding.
![]() |
Remove the protective tape.
| 6. INSTALL REAR DOOR WEATHERSTRIP |
![]() |
Engage the 32 clips and install the rear door weatherstrip.
| 7. INSTALL REAR DOOR CHECK ASSEMBLY |
![]() |
Apply MP grease to the sliding areas of the door check.
Install the rear door check onto the door panel with the 2 bolts.
Apply adhesive to the threads of the bolt.
Install the rear door check onto the body panel with the bolt.
| 8. INSTALL REAR DOOR SERVICE HOLE COVER |
![]() |
Apply butyl tape to the door panel, then install the rear door service hole cover as shown in the illustration.
| Area | Dimension |
| A | 2.0 mm (0.079 in.) or more |
| B | 6.0 mm (0.236 in.) or more |
| 9. INSTALL REAR DOOR TRIM BRACKET |
![]() |
Install the rear door trim bracket with the 2 screws.
| 10. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY |
![]() |
Connect the rear door lock remote control cable and rear door inside locking cable.
![]() |
Engage the 7 clips and install the rear door trim board.
![]() |
Install the screw.
| 11. INSTALL REAR DOOR ARMREST BASE UPPER PANEL (w/o Power Window) |
![]() |
Engage the 4 claws and install the rear door armrest base upper panel.
Install the screw.
| 12. REMOVE REAR DOOR ARMREST BASE UPPER PANEL (w/ Power Window) |
![]() |
Connect the connector.
Engage the 7 claws and 2 clips and install the rear door armrest base upper panel.
Install the screw.
| 13. INSTALL REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window) |
![]() |
Install the window regulator handle plate.
Open all the windows.
![]() |
Install the rear door window regulator handle with the clip at the angle shown in the illustration.
| 14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |