FRONT PASSENGER SIDE POWER WINDOW SWITCH (for Sedan) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE FRONT ARMREST BASE UPPER PANEL |
![]() |
for Driver Side:
Remove the screw.
Disengage the 2 clips and the 7 claws.
Disconnect the connector and remove the front armrest base upper panel.
![]() |
for Front Passenger Side:
Remove the screw.
Disengage the 2 clips and the 7 claws.
Disconnect the 2 connectors and remove the front armrest base upper panel.
| 3. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY |
![]() |
Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the power window regulator switch.