Home › Vehicle Exterior › WINDOW / GLASS › FRONT PASSENGER SIDE POWER WINDOW SWITCH (for Sedan)

FRONT PASSENGER SIDE POWER WINDOW SWITCH (for Sedan) > REMOVAL



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE FRONT ARMREST BASE UPPER PANEL


B136158
  1. for Driver side with power window:

    1. Remove the screw.

    2. Disengage the 7 claws and 2 clips and remove the front armrest base upper panel.

    3. Disconnect the connector.



    B141925
  1. for Front passenger side with power window:

    1. Remove the screw.

    2. Disengage the 7 claws and 2 clips and remove the front armrest base upper panel.

    3. Disconnect the connector.



    B141926
  1. w/o Power window:

    1. Remove the screw.

    2. Disengage the 5 claws and 2 clips and remove the front armrest base upper panel.



3. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY


B141906
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the power window regulator switch.