Home › Vehicle Exterior › WINDOW / GLASS › REAR POWER WINDOW SWITCH (for Sedan)

REAR POWER WINDOW SWITCH (for Sedan) > REMOVAL


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure described below is for the RH side.



1. REMOVE REAR DOOR ARMREST BASE UPPER PANEL


B208702
  1. Remove the screw.

  1. Disengage the 7 claws and 2 clips and remove the rear door armrest base upper panel.

  1. Disconnect the connector.



2. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY


B169342
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the power window regulator switch.