Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW REGULATOR MOTOR (for Sedan Front Side)

POWER WINDOW REGULATOR MOTOR (for Sedan Front Side) > REMOVAL


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure described below is for the LH side.



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


3. REMOVE FRONT DOOR BELT MOULDING
(Click here)


4. REMOVE FRONT DOOR TRIM BRACKET


B136164
  1. Remove the 2 screws and front door trim bracket.



5. REMOVE FRONT DOOR SERVICE HOLE COVER


B136163
  1. Disconnect the connectors and clamps, then remove the front door service hole cover.

    NOTICE:
    Remove any tape remaining on the door side.



6. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY
  1. w/ Power window:

    1. Driver side:
      Provisionally install the power window regulator master switch.

    2. Passenger side:
      Provisionally install the power window regulator switch.

  1. w/o Power window:

    1. Provisionally install the front door window regulator handle.



    B136165
  1. Move the front door glass until the 2 bolts can be seen through the service holes.

  1. Remove the 2 bolts.

    NOTICE:
    Do not drop or damage the front door glass when removing the bolts.



    B136166
  1. Remove the front door glass in the direction indicated by the arrows in the illustration.

    NOTICE:
    Do not damage the glass.

  1. w/ Power window:

    1. Driver side:
      Remove the power window regulator master switch.

    2. Passenger side:
      Remove the power window regulator switch.

  1. w/o Power window:

    1. Remove the front door window regulator handle.



7. REMOVE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY


B136167E01
  1. w/ Power window:

    1. Disconnect the connector.

    2. Loosen bolt A.

    3. Remove the 5 bolts, then remove the front door window regulator.

      NOTICE:
      Do not drop or damage the window regulator when removing the bolts.

      HINT:
      Remove the window regulator through the service hole.



    B136195E01
  1. w/o Power window:

    1. Loosen bolt A.

    2. Remove the 5 bolts, then remove the front door window regulator.

      NOTICE:
      Do not drop or damage the window regulator when removing the bolts.

      HINT:
      Remove the window regulator through the service hole.



8. REMOVE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY


B127213
  1. Using a T25 "TORX" socket wrench, remove the 3 screws and front power window regulator motor assembly.