POWER WINDOW REGULATOR MOTOR (for Sedan Rear Side) > INSTALLATION |
| 1. INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY REAR |
![]() |
Apply MP grease to the sliding and rotating areas of the regulator motor.
Using "TORX" socket wrench T25, install the power window regulator motor with the 3 screws.
| 2. INSTALL REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY |
w/ Power window:
Apply MP grease to the sliding and rotating areas of the rear door window regulator.
![]() |
Loosely bolt A onto the rear door window regulator.
Insert the rear door window regulator into the door panel. Use bolt A to hang the rear door window regulator on the door panel.
Install the rear door window regulator with the 4 bolts, and tighten bolt A.
Connect the connector.
w/o Power window:
Apply MP grease to the sliding and rotating areas of the rear door window regulator.
![]() |
Install the rear door window regulator with the 3 bolts.
| 3. INSTALL REAR DOOR GLASS SUB-ASSEMBLY |
![]() |
w/ Power window:
Install the rear door glass onto the rear door window regulator.
![]() |
w/o Power window:
Install the rear door glass onto the rear door window regulator.
| 4. INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY |
![]() |
Install the rear door window division bar with the 2 bolts and screw.
| 5. INSTALL REAR DOOR GLASS RUN |
![]() |
Install the rear door glass run.
| 6. INSTALL REAR DOOR BELT MOULDING |
![]() |
Engage the 5 claws and install a new rear door belt moulding.
![]() |
Remove the protective tape.
| 7. INSTALL REAR DOOR WEATHERSTRIP |
![]() |
Engage the 32 clips and install the rear door weatherstrip.
| 8. INSTALL REAR DOOR CHECK ASSEMBLY |
![]() |
Apply MP grease to the sliding areas of the door check.
Install the rear door check onto the door panel with the 2 bolts.
Apply adhesive to the threads of the bolt.
Install the rear door check onto the body panel with the bolt.
| 9. INSTALL REAR DOOR SERVICE HOLE COVER |
![]() |
Apply butyl tape to the door panel, then install the rear door service hole cover as shown in the illustration.
| Area | Dimension |
| A | 2.0 mm (0.079 in.) or more |
| B | 6.0 mm (0.236 in.) or more |
| 10. INSTALL REAR DOOR TRIM BRACKET |
![]() |
Install the rear door trim bracket with the 2 screws.
| 11. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY |
![]() |
Connect the rear door lock remote control cable and rear door inside locking cable.
![]() |
Engage the 7 clips and install the rear door trim board.
![]() |
Install the screw.
| 12. INSTALL REAR DOOR ARMREST BASE UPPER PANEL |
![]() |
Connect the connector.
Engage the 7 claws and 2 clips and install the rear door armrest base upper panel.
Install the screw.
| 13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |