Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW REGULATOR MOTOR (for Sedan Rear Side)

POWER WINDOW REGULATOR MOTOR (for Sedan Rear Side) > REMOVAL


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure described below is for the RH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE REAR DOOR ARMREST BASE UPPER PANEL


B208702
  1. Remove the screw.

  1. Disengage the 7 claws and 2 clips and remove the rear door armrest base upper panel.

  1. Disconnect the connector.



3. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY


    B208699
  1. Remove the screw.



    B208700
  1. Disengage the 7 clips.



    B208701
  1. Disconnect the rear door lock remote control cable and rear door inside locking cable and remove the rear door trim board.



4. REMOVE REAR DOOR TRIM BRACKET


    B136209
  1. Remove the 2 screws and the rear door trim bracket.



5. REMOVE REAR DOOR SERVICE HOLE COVER


    B136210
  1. Disconnect the connectors and clamps, then remove the rear door service hole cover.

    NOTICE:
    Remove any tape remaining on the door side.



6. REMOVE REAR DOOR CHECK ASSEMBLY


B136211
  1. Remove the 3 bolts, then remove the rear door check.

    NOTICE:
    Do not drop or damage the door check when removing the bolts.

    HINT:
    Remove the door check through the service hole.



7. REMOVE REAR DOOR WEATHERSTRIP


B136212
  1. Disengage the 32 clips and remove the rear door weatherstrip.

    NOTICE:
    Remove any tape remaining on the door side.



8. REMOVE REAR DOOR BELT MOULDING


    B134880E03
  1. Apply protective tape to the door panel in the periphery of the rear door belt moulding.



    B134881E02
  1. Using a moulding remover, disengage the 5 claws and remove the rear door belt moulding.



9. REMOVE REAR DOOR GLASS RUN


B136213
  1. Remove the rear door glass run.



10. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY


B136214
  1. Remove the 2 bolts, screw and rear door window division bar.

    NOTICE:
    Do not drop or damage the rear door window division bar when removing the bolts and screw.



11. REMOVE REAR DOOR GLASS SUB-ASSEMBLY


B136216
  1. w/ Power window:

    1. Remove the rear door glass from the rear door window regulator.



    B136231
  1. w/o Power window:

    1. Remove the rear door glass from the rear door window regulator.



12. REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY


B136217E01
  1. w/ Power window:

    1. Disconnect the connector.

    2. Loosen bolt A.

    3. Remove the 3 bolts, then remove the rear door window regulator.

      NOTICE:
      Do not drop or damage the rear door window regulator when removing the bolts.

      HINT:
      Remove the window regulator through the service hole.



    B136232
  1. w/o Power window:

    1. Remove the 3 bolts, then remove the rear door window regulator.

      NOTICE:
      Do not drop or damage the rear door window regulator when removing the bolts.

      HINT:
      Remove the window regulator through the service hole.



13. REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY REAR


B132191
  1. Using "TORX" socket wrench T25, remove the 3 screws and power window regulator motor.