Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW MASTER SWITCH (for Sedan)

POWER WINDOW MASTER SWITCH (for Sedan) > INSTALLATION



1. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY


B136183
  1. Install the power window regulator master switch with the 3 screws.



2. INSTALL FRONT ARMREST BASE UPPER PANEL


B136158
  1. for Driver side with power window:

    1. Connect the connector.

    2. Engage the 7 claws and 2 clips and install the front armrest base upper panel.

    3. Install the screw.



    B141925
  1. for Front passenger side with power window:

    1. Connect the connector.

    2. Engage the 7 claws and 2 clips and install the front armrest base upper panel.

    3. Install the screw.



    B141926
  1. w/o Power window:

    1. Engage the 5 clips and 2 clips and install the front armrest base upper panel.

    2. Install the screw.



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }