Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW MASTER SWITCH (for Sedan)

POWER WINDOW MASTER SWITCH (for Sedan) > REMOVAL



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE FRONT ARMREST BASE UPPER PANEL


B136158
  1. for Driver Side:

    1. Remove the screw.

    2. Disengage the 2 clips and the 7 claws.

    3. Disconnect the connector and remove the front armrest base upper panel.



    B141925
  1. for Front Passenger Side:

    1. Remove the screw.

    2. Disengage the 2 clips and the 7 claws.

    3. Disconnect the 2 connectors and remove the front armrest base upper panel.



3. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY


B136183
  1. Remove the 3 screws and the power window regulator master switch.