Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW MASTER SWITCH (for Sedan)

POWER WINDOW MASTER SWITCH (for Sedan) > REMOVAL



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE FRONT ARMREST BASE UPPER PANEL


B136158
  1. for Driver side with power window:

    1. Remove the screw.

    2. Disengage the 7 claws and 2 clips and remove the front armrest base upper panel.

    3. Disconnect the connector.



    B141925
  1. for Front passenger side with power window:

    1. Remove the screw.

    2. Disengage the 7 claws and 2 clips and remove the front armrest base upper panel.

    3. Disconnect the connector.



    B141926
  1. w/o Power window:

    1. Remove the screw.

    2. Disengage the 5 claws and 2 clips and remove the front armrest base upper panel.



3. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY


B136183
  1. Remove the 3 screws and the power window regulator master switch.