Home › Vehicle Interior › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY (for Sedan)

FRONT SEAT INNER BELT ASSEMBLY (for Sedan) > INSPECTION



1. INSPECT FRONT SEAT INNER BELT ASSEMBLY


    B114760E01
  1. for Driver Side:

    1. Check the resistance.

      1. Using an ohmmeter, measure the resistance between the terminals.

        Standard resistance:
        Tester Connection
        Condition
        Specified Condition
        3 - 4
        Tongue plate fastened
        10 kΩ or higher
        Tongue plate released
        Below 1 Ω

        If the result is not as specified, replace the front seat inner belt.



    B114761E01
  1. for Front Passenger Side:

    1. Check the resistance.

      1. Using an ohmmeter, measure the resistance between the terminals.

        Standard resistance:
        Tester Connection
        Condition
        Specified Condition
        1 - 2
        Tongue plate fastened
        10 kΩ or higher
        Tongue plate released
        Below 1 Ω

        If the result is not as specified, replace the front seat inner belt.