Home › Vehicle Interior › SEAT BELT › FRONT PASSENGER SEAT BELT WARNING LIGHT (for Sedan)

FRONT PASSENGER SEAT BELT WARNING LIGHT (for Sedan) > INSTALLATION



1. INSTALL HAZARD WARNING SIGNAL SWITCH ASSEMBLY
  1. Engage the 3 claws and install the hazard warning signal switch.



2. INSTALL INSTRUMENT PANEL CENTER REGISTER ASSEMBLY


    E127121
  1. Engage the 8 claws and the instrument panel center register.



3. INSTALL INSTRUMENT CLUSTER CENTER FINISH PANEL SUB-ASSEMBLY
  1. Engage the 2 claws and 4 clips and install the instrument cluster finish panel center.



4. INSTALL INSTRUMENT CLUSTER FINISH PANEL


E116833
  1. Fit the 2 claws of the instrument cluster finish panel into the upper instrument cluster finish panel center.



    E116834
  1. Engage the 5 claws and 5 clips and install the instrument cluster finish panel.



5. INSTALL INSTRUMENT PANEL FINISH PANEL END RH


B132318
  1. Engage the 6 claws and 3 clips and install the instrument panel finish panel end RH.



6. INSTALL INSTRUMENT PANEL FINISH PANEL END LH


B132317
  1. Engage the 6 claws and 3 clips and install the instrument panel finish panel end LH.



7. INSTALL INSTRUMENT PANEL LOWER CENTER FINISH PANEL


B132316
  1. Engage the 2 claws and 2 clips and install the instrument panel finish panel lower center.