FRONT PASSENGER SEAT BELT WARNING LIGHT (for Sedan) > REMOVAL |
| 1. REMOVE INSTRUMENT PANEL LOWER CENTER FINISH PANEL |
![]() |
Disengage the 2 claws and 2 clips and remove the instrument panel finish panel lower center.
| 2. REMOVE INSTRUMENT PANEL FINISH PANEL END RH |
![]() |
Disengage the 6 claws and 3 clips and remove the instrument panel finish panel end RH.
| 3. REMOVE INSTRUMENT PANEL FINISH PANEL END LH |
![]() |
Disengage the 6 claws and 3 clips and remove the instrument panel finish panel end LH.
| 4. REMOVE INSTRUMENT CLUSTER FINISH PANEL |
![]() |
Disengage the 7 claws and 5 clips and remove the instrument cluster finish panel.
| 5. REMOVE INSTRUMENT CLUSTER CENTER FINISH PANEL SUB-ASSEMBLY |
![]() |
Disengage the 2 claws and 4 clips and remove the instrument cluster finish panel center.
| 6. REMOVE INSTRUMENT PANEL CENTER REGISTER ASSEMBLY |
![]() |
Disengage the 8 claws and remove the instrument panel center register.
| 7. REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY (Built in Front Passenger Seat Belt Warning Light) |
![]() |
Disengage the 3 claws and remove the hazard warning signal switch.