Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMPRESSOR (for Hatchback)

COMPRESSOR (for Hatchback) > INSPECTION



1. INSPECT COMPRESSOR WITH PULLEY ASSEMBLY


    I105051E04
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *a
    Component without harness connected
    (Compressor With Pulley Assembly)

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    2 (SOL+) - 1 (SOL-)
    20°C (68°F)
    10 to 11 Ω

    1. If the result is not as specified, replace the compressor with pulley assembly.