FOG LIGHT ASSEMBLY (for Hatchback) > INSTALLATION |
| 1. INSTALL FOG LIGHT ASSEMBLY |
Engage the guide to install the fog light assembly.
Install the 2 screws.
Connect the connector.
| 2. INSTALL FRONT FENDER LINER |
Install the front fender liner with the 2 screws.
| 3. PREPARE VEHICLE FOR FOG LIGHT AIMING ADJUSTMENT |
Prepare the vehicle:
| 4. PREPARE FOR FOG LIGHT AIMING |
![]() |
| *a | 90° |
| *b | 7.62 or 3 m (25 or 9.84 ft.) |
Prepare the vehicle in accordance with the following conditions:
Prepare a piece of thick white paper (approximately 2 m (6.6 ft.) (high) x 4 m (13.1 ft.) (wide)), to use as a screen.
Draw a vertical line down the center of the screen (V line).
Set the screen as shown in the illustration.

| *a | Aligning distance 7.62 m (25 ft.) | *b | Aligning distance 3 m (9.84 ft.) |
| *c | V RH Line | *d | V LH Line |
| *e | V Line | *f | H Line |
| *g | 7.62 m (25 ft.) | *h | 3 m (9.84 ft.) |
| *i | 90° | - | - |
![]() |
Draw base lines (H line, V LH, V RH lines) on the screen as shown in the illustration.
| *a | V LH Line |
| *b | V Line |
| *c | V RH Line |
| *d | H Line |
| *e | Ground |
H Line (Fog light height):
Draw a horizontal line across the screen so that it passes through the center marks. The H line should be at the same height as the fog light bulb center marks of the fog lights.
V LH Line and V RH Line (Center mark positions of left-hand (LH) and right-hand (RH) fog lights):
Draw two vertical lines so that they intersect the H line at each center mark.
| 5. INSPECT FOG LIGHT AIMING |
Cover the fog light or disconnect the connector of the fog light on the opposite side to prevent light from the fog light is not being inspected from affecting the fog light aiming.
Start the engine.
Turn on the fog light and make sure that the cutoff line falls within the specified area, as shown in the illustration.

| *a | Aligning distance 7.62 m (25 ft.) | *b | Aligning distance 3 m (9.84 ft.) |
| *c | V LH Line | *d | V RH Line |
| *e | H Line | *f | 433 mm (17.06 in.) |
| *g | 52 mm (2.04 in.) | *h | Hot Zone |
| 6. ADJUST FOG LIGHT AIMING |
![]() |
Adjust the fog light aim to within the specified range by turning the aiming screw with a screwdriver.