Home › Vehicle Exterior › LIGHTING (EXT) › LICENSE PLATE LIGHT ASSEMBLY (for Hatchback)

LICENSE PLATE LIGHT ASSEMBLY (for Hatchback) > REMOVAL


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure described below is for the LH side.
  3. The license plate light bulb can be replaced by removing only the license plate light lens. It is not necessary to remove the license plate light assembly.



1. REMOVE BACK DOOR TRIM BOARD


    B271631
  1. Disengage the 11 clips and remove the back door trim board.



2. REMOVE LICENSE PLATE LIGHT ASSEMBLY


    E222142
  1. Disconnect the connector.

  1. Disengage the 2 claws to remove the license plate light assembly.



3. REMOVE LICENSE PLATE LIGHT PACKING
  1. Remove the license plate light packing.



4. REMOVE LICENSE PLATE LIGHT LENS


    E222143
  1. Disengage the 2 claws to remove the license plate light lens.



5. REMOVE LICENSE PLATE LIGHT BULB


    E229112
  1. Remove the license plate light bulb.