Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER (for Hatchback without Sport Package)

FRONT BUMPER (for Hatchback without Sport Package) > DISASSEMBLY

for Preparation Click here



1. REMOVE HOOD TO FRONT END PANEL SEAL


    B283026
  1. Remove the 4 clips.

  1. While peeling off the double-sided adhesive tape, remove the hood to front end panel seal.



2. REMOVE RADIATOR GRILLE SIDE MOULDING LH


    B271819
  1. Disengage the 4 claws and remove the radiator grille side moulding.



3. REMOVE RADIATOR GRILLE SIDE MOULDING RH

HINT:
Use the same procedure as for the LH side.



4. REMOVE RADIATOR GRILLE


    B283027
  1. Remove the 3 clips.



    B283028
  1. Disengage the 14 claws and remove the radiator grille.



5. REMOVE RADIATOR GRILLE (OR FRONT PANEL) EMBLEM


    B283029
  1. Disengage the 4 claws, 2 guides and remove the radiator grill (or front panel) emblem.



6. REMOVE FRONT BUMPER LOWER COVER


    B271822
  1. Disengage the 3 claws and remove the front bumper lower cover.



7. REMOVE FRONT BUMPER HOLE COVER


    B271823
  1. Disengage the 3 claws and remove the front bumper hole cover.



8. REMOVE LOWER NO. 1 RADIATOR GRILLE


    B283030
  1. Disengage the 14 claws and remove the lower No. 1 radiator grille.



9. REMOVE FOG LIGHT ASSEMBLY LH (w/ Fog Light)
  1. Disconnect the connector.



    E222116
  1. Remove the 2 screws.

  1. Disengage the guide to remove the fog light assembly.



10. REMOVE FOG LIGHT ASSEMBLY RH (w/ Fog Light)

HINT:
Use the same procedure as for the LH side.



11. REMOVE FOG LIGHT COVER LH


    B271825
  1. Disengage the 5 claws and remove the fog light cover.



12. REMOVE FOG LIGHT COVER RH

HINT:
Use the same procedure as for the LH side.



13. REMOVE HEADLIGHT ASSEMBLY LH


    E222085
  1. Remove the 3 screws.

  1. Disconnect the connectors and remove the headlight assembly.



14. REMOVE HEADLIGHT ASSEMBLY RH

HINT:
Use the same procedure as for the LH side.



15. REMOVE FRONT BUMPER SIDE RETAINER LH


    B271827
  1. Disengage the 2 claws and remove front bumper side retainer.



16. REMOVE FRONT BUMPER SIDE RETAINER RH

HINT:
Use the same procedure as for the LH side.



17. SEPARATE THERMISTOR ASSEMBLY


    B271830
  1. Disengage the 2 clamps and remove the thermistor.



18. REMOVE NO. 2 RADIATOR SIDE AIR SEAL


    B288477
  1. Disengage the 2 claws and remove the radiator side air seal.



19. REMOVE NO. 1 RADIATOR SIDE AIR SEAL

HINT:
Use the same procedure as for the No. 2 side.



20. REMOVE RADIATOR SUPPORT EXTENSION LH


    B288478
  1. Disengage the 2 claws and remove the radiator support extension.



21. REMOVE RADIATOR SUPPORT EXTENSION RH

HINT:
Use the same procedure as for the LH side.



22. REMOVE FRONT BUMPER REINFORCEMENT


    B271832
  1. Disengage the 2 clamps and the disconnect the wire harness.



    B271833
  1. Remove the 6 bolts.

  1. Remove the 4 nuts and the front bumper reinforcement.



23. REMOVE FRONT NO. 1 BUMPER STONE DEFLECTOR BRACKET


    B288479
  1. Remove the 2 nuts and the front No. 1 bumper stone deflector bracket.

    HINT:
    Use the same procedure as for the opposite side.



24. REMOVE WINDSHIELD WASHER JAR ASSEMBLY (for Cold Area Specification Vehicles)


    B288482
  1. Remove the bolt and separate the windshield washer jar.



25. REMOVE WINDSHIELD WASHER JAR ASSEMBLY (except Cold Area Specification Vehicles)


    B288481
  1. Remove the bolt and separate the windshield washer jar.



26. REMOVE FRONT SIDE MEMBER BRACKET SUB-ASSEMBLY LH


    B288480
  1. Remove the 4 bolts.

  1. Disengage the 2 guides and remove the front side member bracket.



27. REMOVE FRONT SIDE MEMBER BRACKET SUB-ASSEMBLY RH

HINT:
Use the same procedure as for the LH side.