Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR BUMPER (for Hatchback without Sport Package)

REAR BUMPER (for Hatchback without Sport Package) > REASSEMBLY



1. INSTALL REAR NO. 2 BUMPER REINFORCEMENT


    B283041
  1. Engage the 2 guides and install the rear bumper reinforcement.



2. INSTALL REAR BUMPER ARM LH


    B288644
  1. Install the rear bumper arm with the 3 bolts.

    Torque:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf }



3. INSTALL REAR BUMPER ARM RH

HINT:
Use the same procedure as for the LH side.



4. INSTALL REAR NO. 1 BUMPER REINFORCEMENT


    B288643
  1. Install the rear bumper reinforcement with the 4 nuts.

    Torque:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf }



5. INSTALL REAR BUMPER SIDE SUPPORT LH


    B272395
  1. Engage the 2 claws and install the rear bumper side support.

  1. Tighten the screw.



6. INSTALL REAR BUMPER SIDE SUPPORT RH

HINT:
Use the same procedure as for the LH side.



7. INSTALL REAR BUMPER SIDE RETAINER LH


    B272394
  1. Engage the guide and 2 claws and install the rear bumper side retainer.

  1. Tighten the screw.



8. INSTALL REAR BUMPER SIDE RETAINER RH

HINT:
Use the same procedure as for the LH side.



9. INSTALL REAR BUMPER SIDE SEAL LH


    B272396
  1. Install the rear bumper side seal with the 2 clips.



10. INSTALL REAR BUMPER SIDE SEAL RH

HINT:
Use the same procedure as for the LH side.



11. INSTALL REAR BUMPER PLATE LH


    B289850
  1. Engage the 2 claws and install the rear bumper plate.

  1. Tighten the screw.



12. INSTALL REAR BUMPER PLATE RH

HINT:
Use the same procedure as for the LH side.