Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR SPOILER (for Hatchback)

REAR SPOILER (for Hatchback) > INSTALLATION



1. INSTALL REAR SPOILER SUB-ASSEMBLY
  1. Clean the attachment surface.

    1. Using an infrared light, heat the double-sided adhesive tape remaining on the back door panel.
      Heating Temperature 
      Item
      Temperature
      Vehicle Body
      40 to 60°C (104 to 140°F)

      CAUTION:
      Do not burn yourself on the hot back door panel or with the infrared light.

      NOTICE:
      Do not heat the back door panel excessively.

    2. Using a piece of cloth, rub the remaining double-sided tape off the back door panel while it is hot from the infrared light.

      NOTICE:
      Installing the rear spoiler while any double-sided tape remains on the back door panel may cause adhesion failure. Therefore, completely remove the double-sided adhesive tape.

    3. Using a non-residue solvent, clean the attachment surface.

  1. Engage the 4 clips and install a new rear spoiler.

  1. Tighten the 2 screws.



2. INSTALL REAR SPOILER COVER LH


    B273186
  1. Engage the 2 claws and install the rear spoiler cover.



3. INSTALL REAR SPOILER COVER RH

HINT:
Use the same procedure as for the LH side.