Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › BACK DOOR OUTSIDE GARNISH (for Hatchback with Power Door Lock)

BACK DOOR OUTSIDE GARNISH (for Hatchback with Power Door Lock) > INSTALLATION



1. INSTALL BACK DOOR OPENER SWITCH ASSEMBLY
  1. Install the back door opener switch.

    HINT:
    Make sure the arrows on the back door opener switch and the back door garnish are pointing in the same direction.



2. INSTALL BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY
  1. Engage the 2 clips and install the back door outside garnish.

  1. Tighten the 3 nuts.

    Torque:
    4.9 N*m{ 50 kgf*cm , 43 in.*lbf }

  1. Connect the connectors.



3. INSTALL BACK DOOR LOCK CYLINDER ASSEMBLY (w/ Lock Cylinder)


    E228988
  1. Engage the 2 claws and install the back door lock cylinder assembly.



    E228987
  1. Install the back door lock cylinder assembly with the 2 nuts.

    Torque:
    4.9 N*m{ 50 kgf*cm , 43 in.*lbf }

  1. Connect the connector.



4. INSTALL NO. 2 BACK DOOR GARNISH RETAINER (w/ Cover)


    B284625
  1. Install the back door garnish No. 2 retainer with the 2 nuts.

    Torque:
    4.9 N*m{ 50 kgf*cm , 43 in.*lbf }



5. INSTALL REAR WIPER MOTOR ASSEMBLY (w/ Rear Wiper)
(Click here)


6. INSTALL BACK DOOR TRIM BOARD


    B271631
  1. Engage the 11 clips and install the back door trim board.