BACK DOOR OUTSIDE GARNISH (for Hatchback without Power Door Lock) > INSTALLATION |
| 1. INSTALL BACK DOOR OUTSIDE HANDLE SUB-ASSEMBLY |
Install the back door outside handle.
| 2. INSTALL BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY |
Engage the 2 clips and install the back door outside garnish.
Tighten the nut.
| 3. INSTALL BACK DOOR LOCK CYLINDER ASSEMBLY |
Install the back door lock cylinder with the 2 nuts.
![]() |
Connect the back door lock control rod.
| 4. INSTALL BACK DOOR LOCK CONTROL ASSEMBLY |
Install the back door lock control with the 2 nuts.
Connect the back door outside handle cable.
| 5. INSTALL REAR WIPER MOTOR ASSEMBLY (w/ Rear Wiper) |
| 6. INSTALL BACK DOOR TRIM BOARD |
![]() |
Engage the 11 clips and install the back door trim board.