Home › Drivetrain ยท DRIVE SHAFT / PROPELLER SHAFT › FRONT DRIVE SHAFT ASSEMBLY (for TMMF Made Hatchback)

FRONT DRIVE SHAFT ASSEMBLY (for TMMF Made Hatchback) > DISASSEMBLY

for Preparation Click here



1. REMOVE FRONT NO. 2 AXLE INBOARD JOINT BOOT CLAMP


    C286842
  1. Using needle-nose pliers, disengage the 2 claws and remove the front No. 2 axle inboard joint boot clamp.



2. REMOVE FRONT AXLE INBOARD JOINT BOOT CLAMP


    C241821
  1. Using pliers, remove the front axle inboard joint boot clamp as shown in the illustration.



3. SEPARATE FRONT AXLE INBOARD JOINT BOOT
  1. Separate the front axle inboard joint boot from the front drive inboard joint assembly.



4. REMOVE FRONT DRIVE INBOARD JOINT ASSEMBLY
  1. Remove the old grease from the front drive inboard joint assembly.



    C160821E11
  1. Place matchmarks on the front drive inboard joint assembly and the outboard joint shaft assembly.
    Text in Illustration 
    *a
    Matchmark

    NOTICE:
    Do not cause any damage when placing the marks.

  1. Remove the front drive inboard joint assembly from the outboard joint shaft assembly.

  1. Fix the outboard joint shaft assembly in a vise between aluminum plates.

    NOTICE:
    Do not overtighten the vise.



    C160822
  1. Using a snap ring expander, remove the snap ring from the outboard joint shaft assembly.



    F047435E10
  1. Place matchmarks on the tripod joint assembly and the outboard joint shaft assembly.
    Text in Illustration 
    *a
    Matchmark

    NOTICE:
    Do not cause any damage when placing the marks.

  1. Using a brass bar and hammer, remove the tripod joint assembly.

    NOTICE:
    Do not tap the rollers.

  1. Remove the front No. 2 axle inboard joint boot clamp, front axle inboard joint boot and the front axle inboard joint boot clamp.



5. REMOVE FRONT DRIVE SHAFT DAMPER CLAMP RH (for RH Side)


    C231523
  1. Using pliers, remove the front drive shaft damper clamp RH as shown in the illustration.



6. REMOVE FRONT DRIVE SHAFT DAMPER RH (for RH Side)
  1. Remove the front drive shaft damper RH from the outboard joint shaft assembly.



7. REMOVE FRONT NO. 2 AXLE OUTBOARD JOINT BOOT CLAMP


    C160725
  1. Using pliers, remove the front No. 2 axle outboard joint boot clamp as shown in the illustration.



8. REMOVE FRONT AXLE OUTBOARD JOINT BOOT CLAMP


    C201460
  1. Using pliers, remove the front axle outboard joint boot clamp as shown in the illustration.



9. REMOVE FRONT AXLE OUTBOARD JOINT BOOT
  1. Remove the front axle outboard joint boot from the outboard joint shaft assembly.

  1. Remove the old grease from the outboard joint shaft assembly.



10. REMOVE FRONT DRIVE SHAFT DUST COVER


    C235586E02
  1. Using SST and a press, remove the front drive shaft dust cover from the front drive inboard joint assembly.

    SST
    09950-00020  

    NOTICE:
    Do not drop the front drive inboard joint assembly.