Home › Vehicle Interior › DOOR LOCK › DOOR CONTROL RECEIVER (for Hatchback 5 Door)

DOOR CONTROL RECEIVER (for Hatchback 5 Door) > REMOVAL



1. REMOVE DECK BOARD ASSEMBLY


    B272608
  1. Remove the deck board.



2. REMOVE REAR SEAT ASSEMBLY (for 60/40 Split Seat Type LH Side)
(Click here)


3. REMOVE REAR SEAT ASSEMBLY (for 60/40 Split Seat Type RH Side)
(Click here)


4. REMOVE REAR SEAT ASSEMBLY (for Fold Down Seat Type)
(Click here)


5. REMOVE REAR DOOR SCUFF PLATE LH

HINT:
Use the same procedure as for the RH side .



6. REMOVE REAR FLOOR FINISH PLATE


    B272624
  1. Disengage the 4 claws and 4 guides and remove the rear floor finish plate.



7. SEPARATE REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY LH

HINT:
Use the same procedure as for the RH side .



8. SEPARATE REAR DOOR OPENING TRIM WEATHERSTRIP LH
  1. Separate the rear door opening trim weatherstrip.



9. REMOVE NO. 2 ROOM LIGHT ASSEMBLY


    E222045E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the claw.
    Text in Illustration 
    *1
    Protective Tape

  1. Disconnect the connector and remove the No. 2 room light assembly.



10. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

HINT:
Use the same procedure as for the RH side .



11. REMOVE ROOF SIDE INNER GARNISH LH

HINT:
Use the same procedure as for the RH side .



12. REMOVE DOOR CONTROL RECEIVER


    E221626
  1. Disconnect the connector.

  1. Remove the bolt.

  1. Disengage the 2 hooks and remove the door control receiver.