DOOR CONTROL RECEIVER (for Hatchback 3 Door) > REMOVAL |
| 1. REMOVE DECK BOARD ASSEMBLY |
![]() |
Remove the deck board.
| 2. REMOVE REAR SEAT ASSEMBLY (for 60/40 Split Seat Type LH Side) |
| 3. REMOVE REAR SEAT ASSEMBLY (for 60/40 Split Seat Type RH Side) |
| 4. REMOVE REAR SEAT ASSEMBLY (for Fold Down Seat Type) |
| 5. REMOVE FRONT DOOR SCUFF PLATE LH |
| 6. SEPARATE FRONT DOOR OPENING TRIM WEATHERSTRIP LH |
Separate the front door opening trim.
| 7. REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH |
| 8. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH |
| 9. REMOVE NO. 2 ROOM LIGHT ASSEMBLY |
![]() |
Using a screwdriver with its tip wrapped in protective tape, disengage the claw.
| *1 | Protective Tape |
Disconnect the connector and remove the No. 2 room light assembly.
| 10. REMOVE REAR FLOOR FINISH PLATE |
![]() |
Disengage the 4 claws and 4 guides and remove the rear floor finish plate.
| 11. SEPARATE REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY LH |
| 12. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH |
| 13. REMOVE ROOF SIDE INNER GARNISH LH |
| 14. REMOVE DOOR CONTROL RECEIVER |
![]() |
Disconnect the connector.
Remove the bolt.
Disengage the 2 hooks and remove the door control receiver.