Home › Engine / Hybrid System › 1NZ-FE INTAKE / EXHAUST › EXHAUST MANIFOLD (for Hatchback)

EXHAUST MANIFOLD (for Hatchback) > REMOVAL



1. REMOVE AIR FUEL RATIO SENSOR
(Click here)


2. REMOVE REAR CONSOLE BOX ASSEMBLY
(Click here)


3. REMOVE FRONT FLOOR CENTER BRACE


A247272
  1. Remove the 2 bolts and the front floor center brace from the body.



4. REMOVE FRONT EXHAUST PIPE ASSEMBLY


    A250069
  1. Peel back the floor carpet.



    A250070
  1. Disconnect the heated oxygen sensor connector.

  1. Remove the oxygen sensor wire grommet and pass the connector through the hole to the outside of the vehicle.



    A247548
  1. Remove the 2 bolts and 2 compression springs from the exhaust manifold.



    A247550
  1. Remove the 2 bolts and 2 compression springs from the tail exhaust pipe assembly.

  1. Remove the 3 exhaust pipe supports and the front exhaust pipe assembly.



5. REMOVE EXHAUST PIPE GASKET
  1. Remove the exhaust pipe gasket from the exhaust manifold.



6. REMOVE NO. 2 EXHAUST PIPE GASKET
  1. Remove the No. 2 exhaust pipe gasket from the front exhaust pipe assembly.



7. SEPARATE ENGINE MOVING CONTROL ROD


    A250094
  1. Remove the bolt and the engine moving control rod.



8. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR


    A247612
  1. Disengage the 2 wire harness clamps and separate the engine wire harness.

  1. Remove the bolt and the wire harness bracket.



    A166743
  1. Remove the 4 bolts and the No. 1 exhaust manifold heat insulator.



9. REMOVE MANIFOLD SUPPORT BRACKET


    A143272
  1. Remove the 3 bolts and the manifold support bracket.



10. REMOVE EXHAUST MANIFOLD


    A254827
  1. Remove the 3 bolts, 2 nuts and the exhaust manifold.



11. REMOVE EXHAUST MANIFOLD TO HEAD GASKET
  1. Remove the exhaust manifold to head gasket from the cylinder head assembly.