Home › Vehicle Exterior › DOOR / HATCH › BACK DOOR OPENER SWITCH (for Hatchback)

BACK DOOR OPENER SWITCH (for Hatchback) > INSTALLATION



1. INSTALL BACK DOOR OPENER SWITCH ASSEMBLY
  1. Install the back door opener switch.

    HINT:
    Make sure the arrows on the back door opener switch and the back door garnish are pointing in the same direction.



2. INSTALL BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY
  1. Engage the 2 clips and install the back door outside garnish.

  1. Tighten the 3 nuts.

    Torque:
    4.9 N*m{ 50 kgf*cm , 43 in.*lbf }

  1. Connect the connectors.



3. INSTALL BACK DOOR GARNISH NO. 2 RETAINER (w/ Cover)


    B284625
  1. Install the back door garnish No. 2 retainer with the 2 nuts.

    Torque:
    4.9 N*m{ 50 kgf*cm , 43 in.*lbf }



4. INSTALL BACK DOOR LOCK CYLINDER ASSEMBLY (w/ Lock Cylinder)


    E228988
  1. Engage the 2 claws and install the back door lock cylinder assembly.



    E228987
  1. Install the back door lock cylinder assembly with the 2 nuts.

    Torque:
    4.9 N*m{ 50 kgf*cm , 43 in.*lbf }

  1. Connect the connector.



5. INSTALL REAR WIPER MOTOR ASSEMBLY
(Click here)


6. INSTALL BACK DOOR TRIM BOARD


    B271631
  1. Engage the 11 clips and install the back door trim board.