BRAKE FLUID (for Sedan) > REPLACEMENT |
| 1. REMOVE CENTER COWL TOP VENTILATOR LOUVER |
![]() |
Disengage the 3 clips, the 4 claws and the 8 hooks.
Remove the cowl top ventilator louver sub-assembly.
![]() |
Disconnect the washer hoses.
Disengage the 5 hooks.
| 2. FILL RESERVOIR WITH BRAKE FLUID |
![]() |
Disengage the 3 clips and separate the hood to cowl top seal.
Remove the cowl top ventilator louver.
![]() |
Set the brake fluid can upside down on the reservoir.
| 3. REPLACE BRAKE FLUID |
![]() |
Connect a vinyl tube to the bleeder plug.
Depress the brake pedal several times, and then loosen the bleeder plug with the pedal depressed (Procedure 1).
When fluid stops coming out, tighten the bleeder plug, and then release the brake pedal (Procedure 2).
Repeat steps (Procedure 1) and (Procedure 2) until the new brake fluid comes out.
Tighten the bleeder plug completely.
Repeat the above procedure for each wheel to bleed the brake line.
| 4. INSPECT FOR BRAKE FLUID LEAK |
| 5. INSPECT BRAKE FLUID LEVEL |
![]() |
Check the brake fluid level.
| *a | MAX Line |
| *b | MIN Line |
| 6. INSTALL CENTER COWL TOP VENTILATOR LOUVER |
![]() |
Connect the washer hoses.
Engage the 5 hooks.
![]() |
Engage the 8 hooks and the 4 claws.
Install the cowl top ventilator louver sub-assembly with the 3 clips.