AIR CONDITIONING SYSTEM (for Hatchback) > Headlight Signal Circuit |

| 1.INSPECT HEADLIGHT ASSEMBLY |
Check that the headlight comes on when the light control switch is turned to the HEAD position.
| Result | Proceed to |
| NG | A |
| OK (w/ Daytime Running Light System or w/ Theft Deterrent System) | B |
| OK (w/o Daytime Running Light System and w/o Theft Deterrent System) | C |
|
| ||||
|
| ||||
| A | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY - AIR CONDITIONING AMPLIFIER ASSEMBLY) |
Disconnect the 3A instrument panel junction block assembly connector.
Disconnect the D130 air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3A-22 - D130-21 (HLS) | Always | Below 1 Ω |
| 3A-22 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY |
Remove the instrument panel junction block assembly.
Remove the main body ECU from the instrument panel junction block assembly.
Measure the resistance according to the value(s) in the table below.

| *a | Component without harness connected (Instrument Panel Junction Block Assembly) | - | - |
| Tester Connection | Condition | Specified Condition |
| 3A-22 - MB-15 (HRLY) | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||
| 4.CHECK HARNESS AND CONNECTOR (HEADLIGHT DIMMER SWITCH ASSEMBLY - AIR CONDITIONING AMPLIFIER ASSEMBLY) |
Disconnect the D106 headlight dimmer switch assembly connector.
Disconnect the D130 air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D106-20 (H) - D130-21 (HLS) | Always | Below 1 Ω |
| D106-20 (H) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||