Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › IGNITION COIL AND SPARK PLUG (for Hatchback)

IGNITION COIL AND SPARK PLUG (for Hatchback) > INSTALLATION



1. INSTALL SPARK PLUG
  1. Using a 16 mm spark plug wrench, install the 4 spark plugs.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }

    NOTICE:
    If a component has been dropped or subjected a strong impact, replace it.

    HINT:
    Perform "Inspection After Repairs" after replacing the spark plug (Click here).



2. INSTALL NO. 1 IGNITION COIL


  1. Install the 4 No. 1 ignition coils with the 4 bolts.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }


    NOTICE:
    A268161E01
    If the body or cap of the ignition coil is dropped or subjected to a strong impact, replace the ignition coil with a new one.

    Text in Illustration 
    *1
    Body
    *2
    Cap

    HINT:
    Perform "Inspection After Repairs" after replacing the ignition coil assembly (Click here).

  1. Connect the 4 No. 1 ignition coil connectors.



3. INSTALL NO. 2 CYLINDER HEAD COVER
  1. Install the No. 2 cylinder head cover with the 4 nuts.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }