Home › Drivetrain ยท C50 MANUAL TRANSMISSION / TRANSAXLE › TRANSMISSION CONTROL CABLE (for Sedan)

TRANSMISSION CONTROL CABLE (for Sedan) > ADJUSTMENT



1. ADJUST TRANSMISSION CONTROL SELECT CABLE
  1. Remove the console box assembly .



    C106361E01
  1. Remove the clip and disconnect the control select cable from the shift lever assembly.



    C108468E02
  1. Adjust the length of the control select cable.

    1. Slide the adjuster case cover in the direction shown in the illustration (Illustration A).

    2. Gently pull the cable rod toward the rear of the vehicle by hand to pull the cable taut.

    3. Press the lock piece into the adjuster case and lock it (Illustration B).

    4. Slide the cover in the direction shown in the illustration (Illustration C).

      NOTICE:
      Slide the cover past the protrusion portion of the lock piece (Illustration D).

  1. Install the clip to the shift lever assembly.

  1. Install the console box assembly .