TRANSMISSION CONTROL CABLE (for Hatchback) > ADJUSTMENT |
| 1. REMOVE REAR CONSOLE BOX ASSEMBLY |
| 2. ADJUST TRANSMISSION CONTROL SELECT CABLE |
![]() |
Remove the clip and disconnect the control select cable from the floor shift shift lever assembly.
| *1 | Control Select Cable |
![]() |
Slide the adjuster case cover in the direction shown in the illustration.
| *1 | Adjuster Case Cover |
![]() |
Pull out the lock piece from the adjuster case.
| *1 | Lock Piece |
| *2 | Adjuster Case |
| *3 | Cable Rod |
Install the control select cable to the floor shift shift lever assembly with the clip.
Gently pull the cable rod toward the rear of the vehicle by hand to pull the cable taut.
Press the lock piece into the adjuster case and lock it.
![]() |
Slide the adjuster case cover in the direction shown in the illustration.
| *1 | Adjuster Case Cover |
| 3. INSTALL REAR CONSOLE BOX ASSEMBLY |