Home › Drivetrain ยท C50 MANUAL TRANSMISSION / TRANSAXLE › MANUAL TRANSAXLE OIL (for Sedan)

MANUAL TRANSAXLE OIL (for Sedan) > REPLACEMENT



1. DRAIN MANUAL TRANSAXLE OIL
  1. Remove the filler plug and the gasket.

  1. Remove the drain plug and gasket, and then drain the manual transaxle oil.



2. ADD MANUAL TRANSAXLE OIL
  1. Install a new gasket and the drain plug.

    Torque:
    39 N*m{ 400 kgf*cm , 29 ft.*lbf }



    D025304E50
  1. Add manual transaxle oil.
    Text in Illustration 
    *a
    0 to 5 mm (0 to 0.196 in.)

    Manual Transaxle Oil:
    Oil Grade:
    API GL-4
    Viscosity:
    SAE 75W-90
    Standard Capacity:
    1.9 Liters (2.0 US qts, 1.7 Imp. qts)

    NOTICE:
    1. Problems may occur if the oil level is too high or low.
    2. After replacing the oil, drive the vehicle and check the oil level again.

  1. Install the transmission filler plug and a new gasket.

    Torque:
    39 N*m{ 400 kgf*cm , 29 ft.*lbf }



3. INSPECT MANUAL TRANSAXLE OIL


D025304E50
Text in Illustration 
*a
0 to 5 mm (0 to 0.196 in.)
  1. Stop the vehicle in a level place.

  1. Remove the transmission filler plug and the gasket.

  1. Check that the oil surface is within 5 mm (0.20 in.) of the bottom of the transmission filler plug opening.

    Manual Transaxle Oil:
    Oil Grade:
    API GL-4
    Viscosity:
    SAE 75W-90
    Standard Capacity:
    1.9 Liters (2.0 US qts, 1.7 Imp. qts)

    NOTICE:
    1. Excessively large or small amounts of oil may cause problems.
    2. After replacing the oil, drive the vehicle and check the oil level again.

  1. Check for oil leakage when the oil level is low.

  1. Install the transmission filler plug and a new gasket.

    Torque:
    39 N*m{ 400 kgf*cm , 29 ft.*lbf }