Home › Vehicle Exterior › WINDOW / GLASS › WINDOW DEFOGGER SYSTEM (for Hatchback)

WINDOW DEFOGGER SYSTEM (for Hatchback) > TERMINALS OF ECU



CHECK NO. 2 HEATER CONTROL SUB-ASSEMBLY

B290911E01

  1. Disconnect the D129 No. 2 heater control sub-assembly connector.

  2. Measure the voltage and resistance according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    D129-1 (E) - Body ground
    BR - Body ground
    Ground
    Always
    Below 1 Ω
    D129-3 (IG+) - D129-1 (E)
    V - BR
    Ignition power supply
    Ignition switch ON
    11 to 14 V
    Ignition switch off
    Below 1 V

    1. If the result is not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the No. 2 heater control sub-assembly connector.

  4. Measure the voltage according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    D129-2 (RDEF) - D129-1 (E)
    B - BR
    Rear window defogger signal
    Ignition switch ON, rear window defogger switch OFF
    11 to 14 V
    Ignition switch ON, rear window defogger switch ON
    Below 1 V

    1. If the result is not as specified, the No. 2 heater control sub-assembly may have a malfunction.