Home › Engine / Hybrid System › 1NZ-FE LUBRICATION › OIL PRESSURE SWITCH (for Sedan)

OIL PRESSURE SWITCH (for Sedan) > INSTALLATION



1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY


    A050082E04
  1. Apply adhesive to the end 2 or 3 threads of the engine oil pressure switch.

    Adhesive:
    Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

  1. Using a 24 mm deep socket wrench, install the engine oil pressure switch.

    Torque:
    15 N*m{ 153 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Do not start the engine for at least 1 hour after the installation.



    A104877
  1. Connect the engine oil pressure switch connector.



2. INSTALL ENGINE UNDER COVER RH


3. INSTALL ENGINE UNDER COVER LH