Home › Engine / Hybrid System › 1NZ-FE LUBRICATION › OIL PRESSURE SWITCH (for Sedan)

OIL PRESSURE SWITCH (for Sedan) > INSPECTION



1. INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY


    A104877
  1. Disconnect the engine oil pressure switch connector.

  1. Start the engine.



    A166069E01
  1. Using an ohmmeter, check the resistance between the engine oil pressure switch terminal and body ground.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - Switch body
    Engine Stopped
    Below 1 Ω
    1 - Switch body
    Engine Idling
    10 kΩ or higher

    HINT:
    If the value is not as specified, replace the engine oil pressure switch assembly.