BRAKE FLUID (for Hatchback) > REPLACEMENT |
| 1. REMOVE CENTER COWL TOP VENTILATOR LOUVER |
![]() |
Disengage the 2 clips and slide the hood to cowl top seal as shown in the illustration.
![]() |
Disengage the 2 claws and separate the washer hose joint.
Disengage the 2 claws and 6 guides remove the cowl top ventilator louver center.
| 2. FILL RESERVOIR WITH BRAKE FLUID |
![]() |
Fill the reservoir with brake fluid.
| *a | MAX Line |
| *b | MIN Line |
| 3. REPLACE BRAKE FLUID |
![]() |
Connect a vinyl tube to the bleeder plug.
Depress the brake pedal several times, and then loosen the bleeder plug with the pedal depressed (Step C).
At the point where the fluid stops coming out, tighten the bleeder plug, and then release the brake pedal (Step D).
Repeat Steps C and D until the new brake fluid is comes out.
Tighten the bleeder plug.
Repeat the above procedure to bleed the air out of the brake line for each wheel.
| 4. INSPECT FOR BRAKE FLUID LEAK |
| 5. INSPECT FLUID LEVEL |
![]() |
Check the fluid level.
| *a | MAX Line |
| *b | MIN Line |
| 6. INSTALL CENTER COWL TOP VENTILATOR LOUVER |
![]() |
Engage the 2 claws and 6 guides and install the cowl top ventilator louver center.
Engage the 2 claws and install the washer hose joint.
![]() |
Engage the 2 clips and slide the hood to cowl top seal as shown in the illustration.