FRONT CRANKSHAFT OIL SEAL (for Sedan) > INSTALLATION |
| 1. INSTALL OIL PUMP SEAL |
Apply MP grease to the lip of a new oil seal.
![]() |
Using SST and hammer, tap in the oil seal until its surface is flush with the timing chain cover.
| 2. INSTALL CRANKSHAFT DAMPER SUB-ASSEMBLY |
Align the pin hole of the crankshaft damper sub-assembly with the pin of the crankshaft and install the crankshaft damper sub-assembly.
Provisionally install the bolt.
![]() |
Using SST, tighten the bolt while holding the crankshaft damper sub-assembly.
| *a | Hold |
| *b | Turn |
| 3. INSTALL ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH |
Install the engine mounting insulator sub-assembly RH to the transverse engine engine mounting bracket and vehicle with the 5 bolts and nut.
| 4. INSTALL FAN AND GENERATOR V BELT |
Provisionally install the fan and generator V belt onto each pulley.
| 5. ADJUST FAN AND GENERATOR V BELT |
![]() |
Insert an adjusting bar between the engine mounting bracket and generator assembly. Pull the adjusting bar toward the vehicle front to adjust the generator V belt tension .
| *a | OK |
| *b | NG |
![]() |
First tighten bolt A, then tighten bolt B.
| 6. INSPECT FAN AND GENERATOR V BELT |
![]() |
Check the belt for wear, cracks or other signs of damage.
If any of the following defects is found, replace the V-ribbed belt.
![]() |
Check that the belt fits properly in the ribbed grooves.
| *a | CORRECT |
| *b | INCORRECT |
![]() |
Inspect the V belt deflection and tension.
| *A | w/o Air Conditioner |
| *B | w/ Air Conditioner |
| Item | Specified Condition |
| New belt | 8.0 to 9.0 mm (0.31 to 0.35 in) |
| Used belt | 12.5 to 13.5 mm (0.49 to 0.53 in) |
| Item | Specified Condition |
| New belt | 700 to 800 N (71 to 82 kg, 157 to 180 lb) |
| Used belt | 300 to 400 N (31 to 41 kg, 67 to 90 lb) |
| 7. INSPECT FOR OIL LEAK |
| 8. INSTALL ENGINE UNDER COVER RH |
| 9. INSTALL FRONT WHEEL RH |