Home › Engine / Hybrid System › 1NZ-FE ENGINE MECHANICAL › FRONT CRANKSHAFT OIL SEAL (for Sedan)

FRONT CRANKSHAFT OIL SEAL (for Sedan) > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL RH


2. REMOVE ENGINE UNDER COVER RH


3. REMOVE FAN AND GENERATOR V BELT


    A116197E01
  1. Loosen bolts A and B.

  1. Release the fan and generator V belt tension and remove the fan and generator V belt.



4. REMOVE ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH


A245785E01
  1. Place a wooden block on a jack underneath the oil pan sub-assembly.
    Text in Illustration 
    *1
    Wooden Block

    NOTICE:
    To prevent the No. 2 oil pan sub-assembly from deforming, do not place any attachments onto the No. 2 oil pan sub-assembly.



    G100143
  1. Remove the 5 bolts, the nut and the engine mounting insulator sub-assembly RH from the transverse engine engine mounting bracket and the vehicle.



5. REMOVE CRANKSHAFT DAMPER SUB-ASSEMBLY


A116203E05


  1. Set the No. 1 cylinder to TDC/compression.

    1. Turn the crankshaft damper sub-assembly, and align its timing notch with timing mark "0" of the oil pump assembly.
      Text in Illustration 
      *a
      Timing Mark



    2. A116204E07
    3. Check that the timing marks on the camshaft timing sprocket and the camshaft timing gear assembly are all facing upward as shown in the illustration.
      Text in Illustration 
      *a
      Timing Mark
      If not, turn the crankshaft 1 complete revolution (360°) and align the marks as above.



    A280793E01
  1. Using SST, loosen the bolt while holding the crankshaft damper sub-assembly.
    Text in Illustration 
    *a
    Hold
    *b
    Turn

    SST
    09213-58014   (90201-08131, 91111-50845)
    09330-00021   (09330-00030)

    NOTICE:
    Check the SST installation positions when installing them, to avoid the SST fixing bolts from coming into contact with the oil pump assembly.

  1. Remove the SST and the bolt.

  1. Remove the crankshaft damper sub-assembly from the crankshaft.



6. REMOVE OIL PUMP SEAL


A166924E03
  1. Using a knife, cut off the lip of the oil seal.
    Text in Illustration 
    *a
    Cut Position

  1. Using a screwdriver with its wrapped with tape, pry out the oil seal.

    NOTICE:
    After removing, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.