Home › Engine / Hybrid System › 1NZ-FE ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL (for Sedan)

REAR CRANKSHAFT OIL SEAL (for Sedan) > REMOVAL

for Preparation Click here



1. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY (for Automatic Transaxle)
(Click here)


2. REMOVE MANUAL TRANSAXLE ASSEMBLY (for Manual Transaxle)
(Click here)


3. REMOVE CLUTCH COVER ASSEMBLY (for Manual Transaxle)


    D025280E12
  1. Align the matchmark on the clutch cover assembly with the one on the flywheel.
    Text in Illustration 
    *a
    matchmarks

  1. Loosen each set bolt one turn at a time until the spring tension is released.

  1. Remove the set bolts and pull off the clutch cover.

    NOTICE:
    Do not drop the clutch disc.



4. REMOVE CLUTCH DISC ASSEMBLY (for Manual Transaxle)


5. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transaxle)


A166739E01
  1. Hold the crankshaft with SST.

    SST
    09960-10010   (09962-01000, 09963-01000)



    A190869
  1. Remove the 6 bolts, rear drive plate spacer, drive plate and ring gear sub-assembly, and front drive plate spacer.



6. REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transaxle)


A166739E01
  1. Hold the crankshaft with SST.

    SST
    09960-10010   (09962-01000, 09963-01000)



    A166741
  1. Remove the 6 bolts and flywheel.



7. REMOVE REAR ENGINE OIL SEAL


A166928E04
  1. Using a knife, cut off the lip of the oil seal.
    Text in Illustration 
    *a
    Cut Position

  1. Using a screwdriver with its tip wrapped with tape, pry out the oil seal.

    NOTICE:
    After removing, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.