Home › Vehicle Interior › DOOR LOCK › DOOR CONTROL RECEIVER (for Sedan)

DOOR CONTROL RECEIVER (for Sedan) > INSTALLATION



1. INSTALL DOOR CONTROL RECEIVER
  1. Engage the 2 hooks and install the door control receiver with the bolt.

    Torque:
    7.4 N*m{ 75 kgf*cm , 65 in.*lbf }

  1. Connect the connector.



2. INSTALL ROOF SIDE INNER GARNISH LH

HINT:
Use the same procedure as for the RH side .



3. INSTALL REAR SEAT SIDE COVER LH

HINT:
Use the same procedure as for the RH side .



4. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH

HINT:
Use the same procedure as for the RH side .



5. INSTALL REAR DOOR SCUFF PLATE LH

HINT:
Use the same procedure as for the RH side .



6. INSTALL REAR SEAT ASSEMBLY LH
(Click here)