Home › Engine / Hybrid System › 1NZ-FE STARTING › STARTER (for Hatchback for Cold Area Specification Vehicles)

STARTER (for Hatchback for Cold Area Specification Vehicles) > REMOVAL



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work. (Click here)



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


3. REMOVE FLYWHEEL HOUSING SIDE COVER


    A257703
  1. Disengage the claw by pulling it outward and remove the flywheel housing side cover.



4. REMOVE STARTER ASSEMBLY


    A181245E01
  1. Remove the terminal cap.

  1. Remove the nut and disconnect terminal 30.

  1. Disconnect the connector.

  1. Remove the 2 bolts and starter assembly.
    Text in Illustration 
    *1
    Terminal 30