Home › Vehicle Exterior › WIPER / WASHER › WASHER NOZZLE (for Hatchback Front Side)

WASHER NOZZLE (for Hatchback Front Side) > REMOVAL



1. REMOVE FRONT WIPER ARM HEAD CAP


  1. Type A:



      E273232E03
    1. Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws to remove the front wiper arm head cap.
      Text in Illustration 
      *a
      Protective Tape



  1. Type B:



    1. Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws.


      E263512E01


      Text in Illustration 
      *a
      Protective Tape
      -
      -

    2. While rotating the front wiper arm head cap, disengage the claw to remove the front wiper arm head cap.



2. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY


  1. Type A:



      E228992
    1. Disconnect the washer hose.



  1. Type B:



      E271677
    1. Disconnect the washer hose.



    E228993E01
  1. Remove the nut and the front wiper main arm.
    Text in Illustration 
    *1
    Front Wiper Main Arm



    E258165E02
  1. Apply protective tape to the areas shown in the illustration.
    Text in Illustration 
    *a
    Protective Tape



    E258166E02
  1. Twist a rope around the front wiper sub arm at the area shown in the illustration and pull the rope upward to disengage and remove the front wiper arm and blade assembly.
    Text in Illustration 
    *a
    Head of the Front Wiper Sub Arm
    *b
    Rope

    NOTICE:
    1. If you forcibly disengage the front wiper sub arm in the incorrect direction, it could be deformed or damaged.
    2. If you forcibly pry off the front wiper main arm or front wiper sub arm, the joint section on the end of the front wiper arm could be deformed or damaged.



3. REMOVE WASHER NOZZLE SUB-ASSEMBLY


  1. Type A:



      E263508
    1. Disengage the 2 claws to remove the washer nozzle sub-assembly.



  1. Type B:



      E271798
    1. Disengage the 2 claws to remove the washer nozzle sub-assembly.



    2. E271797
    3. Disconnect the washer hose.