Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT DOOR BELT MOULDING (for Hatchback)

FRONT DOOR BELT MOULDING (for Hatchback) > REMOVAL


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure described below is for the LH side.



1. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY
(Click here)


2. REMOVE FRONT DOOR WINDOW FRAME REAR MOULDING (for 3 Door)
(Click here)


3. REMOVE FRONT DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY


    B272505E02
  1. Apply protective tape to the door panel in the area around the front door glass outer weatherstrip.
    Text in Illustration 
    *1
    Protective Tape



    B272506E02
  1. Using a moulding remover, disengage the 6 claws and remove the front door glass outer weatherstrip.
    Text in Illustration 
    *1
    Moulding Remover