REAR DOOR SPEAKER (for Hatchback) > INSTALLATION |
| 1. INSTALL REAR SPEAKER ASSEMBLY |
![]() |
Using an air riveter or hand riveter, install the rear speaker assembly onto the rear door panel with 3 new strike rivets.
![]() |
![]() |
![]() |
Connect the connector.
| 2. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY |
![]() |
Connect the rear door lock remote control cable assembly and the rear door inside locking cable assembly to the rear door inside handle sub-assembly.
| *1 | Rear Door Lock Remote Control Cable Assembly |
| *2 | Rear Door Inside Locking Cable Assembly |
![]() |
Engage the 7 clips and install the rear door trim board sub-assembly.
![]() |
Install the 3 screws.
![]() |
Engage the claw and close the cover.
| 3. INSTALL REAR DOOR ARMREST BASE PANEL UPPER (w/ Power Window) |
![]() |
Connect the connector.
Engage the 9 claws and the 3 guides, and install the rear door armrest base upper panel.
| 4. INSTALL REAR DOOR ARMREST BASE PANEL UPPER (w/o Power Window) |
![]() |
Engage the 5 claws and 2 guides, and install the rear door armrest base upper panel.
| 5. INSTALL REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window) |
![]() |
Install the window regulator handle plate.
| *a | Inside of Vehicle |
Open all the windows.
![]() |
Install the rear door window regulator handle assembly with the clip at the angle shown in the illustration.
| *a | Assemble with Glass in Fully Open Position |
| 6. INSTALL REAR DOOR FRAME GARNISH |
![]() |
Engage the guide.
Engage the 2 clips and the claw, and install the rear door frame garnish.