Home › Audio / Visual / Telematics › AUDIO / VIDEO › REAR DOOR SPEAKER (for Hatchback)

REAR DOOR SPEAKER (for Hatchback) > REMOVAL


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure described below is for the RH side.



1. REMOVE REAR DOOR FRAME GARNISH


    B271672
  1. Disengage the claw and the 2 clips.

  1. Disengage the guide and remove the rear door frame garnish.



2. REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)


    B345202E04
  1. Insert a clip remover with its shaft wrapped in protective tape between the window regulator handle plate and rear door trim board sub-assembly.
    Text in Illustration 
    *a
    Protective Tape

  1. Turn the rear door window regulator handle assembly with the clip remover inserted, as shown in the illustration.

  1. Remove the rear door window regulator handle assembly and the clip.

  1. Remove the window regulator handle plate.



3. REMOVE REAR DOOR ARMREST BASE PANEL UPPER (w/ Power Window)


    B271671
  1. Using a moulding remover, disengage the 9 claws and 3 guides.

  1. Disconnect the connector and remove the rear door armrest base upper panel.



4. REMOVE REAR DOOR ARMREST BASE PANEL UPPER (w/o Power Window)


    B271670
  1. Using a moulding remover, disengage the 5 claws and 2 guides, and remove the rear door armrest base upper panel.



5. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY


    B273457E03
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the claw and open the cover.
    Text in Illustration 
    *a
    Protective Tape



    B271673
  1. Remove the 3 screws.



    B271674
  1. Disengage the 7 clips.



    B271675E01
  1. Disconnect the rear door lock remote control cable assembly and the rear door inside locking cable assembly, and remove the rear door trim board sub-assembly.
    Text in Illustration 
    *1
    Rear Door Lock Remote Control Cable Assembly
    *2
    Rear Door Inside Locking Cable Assembly



6. REMOVE REAR SPEAKER ASSEMBLY


    E222077
  1. Disconnect the connector.



    E222078
  1. Drill out the 3 rivet heads using a drill with a bit diameter of less than 4 mm (0.16 in.), and remove the rear speaker assembly from the rear door panel.

  1. Operate the drill around the rivet head circumference and cut out the flange.

    CAUTION:
    Be careful. The cut rivet is very hot.

    NOTICE:
    Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill the rivet head straight out.

  1. After drilling out the flange, continue drilling to push out the shards on the drill.

  1. Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.