STEERING PAD SWITCH (for Hatchback) > INSPECTION |
| 1. INSPECT STEERING PAD SWITCH ASSEMBLY |
Measure the resistance according to the value(s) in the table below.

| *a | Component without harness connected (Steering Pad Switch Assembly) | *b | SEEK+ |
| *c | SEEK- | *d | VOL+ |
| *e | VOL- | *f | MODE |
| Tester Connection | Switch Condition | Specified Condition |
| 10 (AU1) - 8 (EAU) | No switch pushed | 95 to 105 kΩ |
| 9 (AU2) - 8 (EAU) | No switch pushed | 95 to 105 kΩ |
| 10 (AU1) - 8 (EAU) | VOL+ switch: pushed | 950 to 1050 Ω |
| 9 (AU2) - 8 (EAU) | VOL+ switch: pushed | 95 to 105 kΩ |
| 10 (AU1) - 8 (EAU) | VOL- switch: pushed | 2955 to 3265 Ω |
| 9 (AU2) - 8 (EAU) | VOL- switch: pushed | 95 to 105 kΩ |
| 10 (AU1) - 8 (EAU) | SEEK+ switch: pushed | Below 2.5 Ω |
| 9 (AU2) - 8 (EAU) | SEEK+ switch: pushed | 95 to 105 kΩ |
| 10 (AU1) - 8 (EAU) | SEEK- switch: pushed | 313 to 345 Ω |
| 9 (AU2) - 8 (EAU) | SEEK- switch: pushed | 95 to 105 kΩ |
| 10 (AU1) - 8 (EAU) | MODE switch: pushed | 95 to 105 kΩ |
| 9 (AU2) - 8 (EAU) | MODE switch: pushed | Below 2.5 Ω |