BACK-UP LIGHT SWITCH (for Hatchback) > INSPECTION |
| 1. INSPECT BACK UP LIGHT SWITCH ASSEMBLY |
![]() |
Measure the resistance according to the value(s) in the table below.
| *a | Component without harness connected (Back Up Light Switch Assembly) |
| *b | 1.1 mm (0.0433 in.) |
| *c | ON |
| *d | OFF |
| Tester Connection | Switch Condition | Specified Condition |
| 1 - 2 | Pushed (ON) | Below 1 Ω |
| 1 - 2 | Released (OFF) | 10 kΩ or higher |